PowerResins TEMP Resin (1 KG)

1- Washing

After the printing is completed, wash the part as attached to the building plate with ethyl alcohol (>%90) or isopropyl alcohol (>%90) for 5 minutes. Make sure that alcohol covers the part entirely when washing. Since the Temp resin is biocompatible never wash it with the alcohol used for other resins before. Use a brush to remove uncured resin if needed. Do not over-wash, it may cause deterioration in dimensions of the part.

2- Drying

Use air-compressor to dry the washed part. Make sure that the part is dry and uncured resin is cleaned up completely. If there is still uncured resin left on the part, wash it with fresh alcohol and dry again.

3- Part Removal

Remove the printed part from the build plate using a scraping tool. Be very careful not to damage the model.

4- Post Curing 20 minutes with MEDIFIVE curing chamber at 3rd-degree light intensity Otoflash curing recommendations 126 MPa flexural strength with 10000 flashes without gas. For the multiunit implant applications if you would like to reach the PMMA level, we recommend curing with gas(nitrogen, argon). After the post curing, supports should be removed from the model cautiously and then desired sandblasting and polishing can be done.

Storage Conditions

Store the PowerResins Temp bottle in dark and moisture free place at room temperature (20-24 °C).

Do not forget shaking the resin well before use.

If your printer has heater, you can set the temperature at 32 °C. Otherwise, you can heat your resin in a microwave for 18 seconds or by submerging in hot water for 15-20 minutes.