- Tear resistance gingival masks
- Flexible and easy to trim
- Produced under ISO standards 13485:2016
If you're using a third-party printer specifically LCD technology without a built-in heater, we recommend preheating the resin to 37°C for optimal results.
*Disclaimer: All European customers please add your valid VAT number during check out!
POST PROCESS
1- Washing
After the printing is completed, wash the part as attached to the building plate with ethyl alcohol (>%90) or isopropyl alcohol (>%90) for 5 minutes. Make sure that alcohol covers the part entirely when washing. Do not over-wash, it may cause deterioration in dimensions of the part.
2- Drying
Use air-compressor to dry the washed part. Make sure that the part is dry and uncured resin is cleaned up completely. If there is still uncured resin left on the part, wash it with fresh alcohol and dry again.
3- Part Removal
Remove the printed part from the build plate using a scraping tool. Be very careful not to damage the model.
4- Post Curing
Post curing application does not significantly affect the Gingiva resin's mechanical properties. However, post-curing helps to remove the stickiness on the printed pieces; thus, the following process is suggested for easy use: 10 minutes with MEDIFIVE curing chamber at 3rd-degree light intensity Otoflash curing recommendations 1000 flashes without gas.
Storage Conditions
Store the PowerResins Temp bottle in dark and moisture free place at room temperature (20-24 °C).
Do not forget shaking the resin well before use.
If your printer has heater, you can set the temperature at 32 °C. Otherwise, you can heat your resin in a microwave for 18 seconds or by submerging in hot water for 15-20 minutes.