- High detailed prints, easy to control margin lines and anatomical details
- Thermoforming models for orthodontic applications
- MMA free organic chemistry formulation, not smelly
- Produced under ISO standards 13485:2016
If you're using a third-party printer specifically LCD technology please make sure to add PRIMER product to your order to avoid adhesion issues and print failures. Furthermore, if your 3D printer is without a built-in heater, we recommend preheating the resin to 37°C for optimal results.
*Disclaimer: All European customers please add your valid VAT number during check out!
POST PROCESS
1- Washing
After the printing is completed, wash the part as attached to the building plate with ethyl alcohol (>%90) or isopropyl alcohol (>%90) for 5 minutes. Make sure that alcohol covers the part entirely when washing. Use a brush to remove uncured resin if needed. Do not over-wash, it may cause deterioration in dimensions of the part.
2- Drying
Use air-compressor to dry the washed part. Make sure that the part is dry and uncured resin is cleaned up completely. If still uncured resin left on the part, wash it with fresh alcohol and dry again.
3- Part Removal
Remove the printed part from the building plate using a scraping tool. Be very careful not to damage the model.
4- Post Curing
You can reach 99 MPa flexural strength after curing Please cure 20 minutes with MEDIFIVE curing chamber at 3rd-degree light intensity Otoflash curing recommendations; 10000 flashes without gas. After post curing, supports should be removed from the model cautiously.
Storage Conditions
Store the PowerResins Model bottle in dark and moisture free place at room temperature (20-24 °C).
Do not forget shaking the resin well before use.
If your printer has heater, you can set the temperature at 32 °C. Otherwise, you can heat your resin in a microwave for 18 seconds or by submerging in hot water for 15-20 minutes.